Firestone 2239 Інструкція з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Повітряний компресор Firestone 2239. Firestone 2239 4 сторінки. Air compressor accessory kit

Друкувати сторінку

Figure "C"

FUSE HOLDER

Figure "D"

8 - T

TEP

EST THE SYSTEM

Re-attach the negative terminal on the battery. Turn on the vehicle's ignition. The air compressor will run for a short

time to build pressure in the tank. Once the pressure reaches 120 psi in the air tank, the pressure switch will turn the

compressor off. It will not restart until the pressure in the tank drops below 90 psi.

SING THE

OMPRESSOR

Your system is now ready to use. With the coiled tubing provided, attach the end with the coupler fitting to the bulk-

head fitting. Install the coupler fitting on the gauge unit then attach the gauge unit to the coiled tubing You can now use

the air chuck gauge unit for inflation.

ILTER MAINTENANCE

It is recommended that the air compressor filter be inspected periodically. If the filter is sufficiently clogged with

road debris or moisture, it will require replacement.

6 - R

TEP

Route a length of air line tubing from the push-to-connect fitting on

the air tank to the T-fitting on the compressor. See Figure "A".

Route a length of the airline tubing from the tank to the bulk head

fitting, see Figure "A". Route the air line to avoid sharp edges or heat

from the engine or exhaust system. Using a razor knife, make the cut

as square as possible and push the air line into the fittings as far as

possible. Do not fold or kink the air line tubing.

7 - W

TEP

Strip 1/4" off the end of the red 14 gage wire supplied with the kit.

Crimp a female spade connector onto the end of the red wire. Install

the female spade connector onto the remaining spade on the pressure

switch. Using a wire connector, attach the opposite end of the wire to

an ignition activated, positive 12 Volt, 25 Amp minimum power

source. Consult the manufacturer's wiring diagram for your

vehicle. Slip the wire connector over the existing ignition activated

wire and insert the un-stripped 14 gage wire into the connector. Close

the wire connector over the wires with pliers, see Figure "C".

Install an in-line fuse in the 14 gage power wire, as close to the

power source as conveniently possible. Cut the 14 gage wire and

insert the un-stripped ends into the fuse holder. Close the fuse holder

with pliers and insert a 25 Amp blade fuse. See Figure "D".

NOTE: Should additional wire be necessary, 14 gage multistrand

wire may be used.

CCESSORY

OUTE THE AIR LINE TUBING

IRE THE SYSTEM

Figure "E"