DIR Orion H136WM Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Фен для волосся DIR Orion H136WM. DIR Orion H136WM 9 сторінок. Wall mounted
Друкувати сторінку1 PRE-INSTALLATION
1-1 OBSERVE THE CARTON OUTSIDE Please check whether the
weight capacity ofthe carton is in accordance with the net weight
nominal ofthe head assembly, if the nominal is in accordance with
the weight capacity,then you can enter into the next installation .
1-2 SPARE PARTS (Please see the below pictures) Open the
carton. check the arm assemblv and see whether it is damaged the
spare parts are complete or not, please see the below
pictures(Remark: The wall plate and wall bracket are attached
together with bolts before the factory delivers the machine.)
Arm Assembly
Washer
Washer x2
Bolt x3
Hex Bolt x2
Hex Wrench
2 INSTALLATION OF WALL BRACKET
2-1. Installation of Wall Mount Arm
Before Installation
1.Wall
The wall must be strong enough to
support the arm assembly.
2.Height
The recommended height of the wall
bracket is 72.5/77 inches from
the floor to the bottom of the bracket (see
diagram)
3.Electric Source
An electrical power outlet must be
prepared on the wall within
48 inches distance from the wall bracket.
Wall Brecket
Wall Plate
Nut x3
Washer x3
57.87"
64.17"
2-2. The wall plate and wall bracket are
already attached together with bolts
upon delivery. (See diagram)
2-4. Use the wall plate as a template and drill
three holes on the wall (please refer to diagram
for the correct drill positioning). The size and
depth of the holes will be in accordance with
the bolts supplied.
Wall
Wall Plate
1.97"
2.34"
Wall
Bolt
Caution! As the wall plate and wall bracket are subject to a large load,
please make sure that the wall plate is installed correctly and securely.
Do not remove stopper on arm until the machine head is correctly
installed. The arm assembly is spring loaded and could cause damage
to equipment and customers if not handled correctly.
2-3. With the supplied spanner, loosen the bolts and
remove the wall plate
Wall Brecket
Wall Plate
Washer
Hex Bolt
Wall Brecket
Wall Plate
2-5. Attach the wall bracket to
the wall with the bolts, and then
fix with the supplied washers.
Wall
Bolt
Washer x3
Nut x3
2-6 Attach the wall bracket to the wall
plate, and then tighten with bolts.
Wall Plate
Wall Brecket
Washer