AeraMax AM IV Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з монтажу для Очищувач повітря AeraMax AM IV. AeraMax AM IV 6 сторінок. Pro air quality control system

Друкувати сторінку

MOUNTING REAR HOUSING AND MAIN ASSEMBLY

Test the electrical outlet box first to ensure rated power requirements are met before beginning installation.

Remove air purifier from its shipping carton and remove all packing material.

Fig 3

Place the air purifier face up on a

flat, stable work surface. Open the

access panel by pressing in latches

on each side of the unit (Fig 3).

Fig 7

REAR HOUSING INSTALLATION & WIRING

Reference rear housing and locate desired mounting location. Again, it is strongly recommended at least 2 mounting anchors for the air purifier be mounted to

an existing stud.

Fig 9

Fig 11

Attach wires from electrical outlet box to wires located inside rear housing using wire nuts. Match up line (black) and neutral (white) wires (Fig 11). Make sure

all connections are made in accordance with federal, state and local codes and regulations.

Fig 4

Open access panel and remove

filter assembly by pulling out on

top of side edges of frame, then

lifting. NOTE: remove all plastic

wrap from filters (Fig 4).

Fig 8

Using provided template ensure electrical

outlet box is located behind cable hole (A)

in Rear Housing assembly (Fig 9). Drill

holes and place anchors in wall.

If mounting on concrete, cinder block or

brick type walls route the wires through

the "punch-out" hole marked (B) in Fig 9.

Fig 5

Fig 6

Remove the six housing screws (Fig 5 & 6) and set aside for re-assembly.

At the location of the two upper

housing corner screws (Fig 5), insert

a flat head screwdriver and gently

twist to release tab as shown in Fig

7. This will disconnect main housing

assembly from the rear housing

assembly.

Fig 10

Disconnect main housing assembly

from rear housing assembly.

Separate main housing from rear

housing. Lift main housing assembly

away from rear mounting housing

(Fig 8).

Check for washers at all mounting

screw locations (Fig 10). Pull wires

from electrical outlet box through

hole in rear housing. Align housing

over anchors and securely install all

mounting screws.