AeraMax Pro AM II Посібник - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник для Очищувач повітря AeraMax Pro AM II. AeraMax Pro AM II 9 сторінок.

Друкувати сторінку

DISPLAY PANEL

NOTE: after the unit is turned on the "AQ" light will flash for a few minutes while the system self-calibrates.
1
AIR QUALITY SENSOR – This indicator monitors the air quality and
adjusts the fan speed to keep your air purified. Blue indicates a low
level of contaminants detected, amber indicates a moderate level of
contaminants and red indicates a high level of contaminants.
2
AUTO MODE – To select, press and hold the button until icon
illuminates. This mode monitors air quality, motion, and noise level
to adjust the fan speed in order to keep your air purified as quickly
as possible. The fan has 5 speeds and can reach turbo speed to clean
the room in the case of high levels of contaminant. The number of tick
marks illuminated around this icon indicates fan speed.
3
MANUAL MODE – To select, press the button until icon illuminates.
This mode allows you to choose one of the 5 fan speeds and keep
the unit at this speed until AUTO MODE is chosen again. The internal
sensors will not adjust the fan speed in this mode. The number of tick
marks illuminated around the AUTO MODE icon indicates fan speed.
*Note - if hybrid filter is being used, both the HEPA and Carbon indicators will be lit.
4
1
2
3
CARBON
HEPA
4
5
4
PlasmaTRUE™ TECHNOLOGY – Creates an ionized field to help
safely remove airborne pollutants. To turn on and off the PlasmaTRUE™
TECHNOLOGY, touch and hold the PLASMA indicator. A blue light
illuminates when the PlasmaTRUE™ TECHNOLOGY is enabled. To disable
the PlasmaTRUE™ TECHNOLOGY, press and hold "Plasma" indicator
until light is off.
5
CARBON FILTER REPLACEMENT INDICATOR* – If the light is red
this indicates the filter needs replacing. The replacement period will
vary depending on the filters used, hours of use, air quality, and rate
of air flow. For filter replacement indicator descriptions see FILTER
REPLACEMENT section.
6
HEPA FILTER REPLACEMENT INDICATOR* – If the light is red
this indicates the filter needs replacing. The replacement period will
vary depending on the filters used, hours of use, air quality, and rate
of air flow. For filter replacement indicator descriptions see FILTER
REPLACEMENT INDICATORS section.
6