AeraMax Pro AM IV Посібник - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник для Очищувач повітря AeraMax Pro AM IV. AeraMax Pro AM IV 19 сторінок. Air quality control system
Також для AeraMax Pro AM IV: Інструкція з експлуатації (6 сторінок)

Друкувати сторінку

CARE AND MAINTENANCE

CLEANING:

• Clean external housing as necessary by wiping with a dry, soft cloth; for stains, use a warm, damp cloth.

• Do not use volatile fluids such as benzene, paint thinner, scouring powder or other cleaners that may damage the unit surface.

• Clean intake and exhaust vents by wiping with a dry, soft cloth.

FILTER REPLACEMENT INDICATORS:

The replacement filter indicators will signal when to replace the HEPA Filter and/or Carbon with Pre-Filter. The replacement period will vary depending on the hours of use, air

quality, and rate of air flow. However, under normal usage, most HEPA Filters need to be replaced every 2 years, and Carbon with Pre-Filter every 6 months. When a filter needs to

be replaced the following color will be shown on any one of the HEPA, CARBON, or ACCESSORY filter replacement indicators:

Red Flashing = RIGHT filter 90% full

Amber Flashing = LEFT filter 90% full

Red Flash, Pause, Amber Flash, Pause = Right & LEFT filters 90% full

Red = Replace RIGHT filter

Amber = Replace LEFT filter

Red & Amber Alternating = Replace Right & Left filters

Do not wash and reuse any of the filters – they will not work effectively. Only use AeraMax ® PRO brand replacement filters as units will not function using any other replacements.

FILTER REPLACEMENT PROCEDURE:

Unlock access panel: to unlock, insert the

key provided and rotate counter-clockwise

¼ turn.

FILTER REPLACEMENT:

When installing a new filter the unit will automatically detect the filter type but the user will have to manually reset the filter replacement indicators. To reset the flashing filter

replacement indicator use the following procedure:

Touch and hold the illuminated

indicator for three seconds until

a beep is heard and the indicator

is flashing green.

Note: If you do not complete step three within 10 seconds of completing step 1 then the indicator light will not be reset.

TROUBLESHOOTING

PROBLEM:

The air quality control system fails to start.

The unit makes a faint ticking sound.

The HEPA and/or Carbon Filter replacement indicator light

remain lit after replacing the filter(s).

Open front access panel by pressing latches

on both sides of unit. Allow panel to open

fully. Remove filter(s) to be replaced.

Release finger from indicator.

POSSIBLE SOLUTION:

• Check to assure unit is connected to power supply.

• Make sure filters are genuine AeraMax

brands. IMPORTANT: Make sure filter detection area on genuine AeraMax

replacement filter aligns with window in filter frame.

• Review "Re-Installing Filters" section for further detail.

• Make sure front access panel is closed completely.

• Make sure power switch is on.

This indicates that the "PlasmaTRUE™" bipolar ionizer is working.

•

• Repeat filter light reset instruction.

Remove any packaging wrap from the

new filters(s) and re-install the filters.

Touch and hold the indicator for three

seconds until a beep is heard and the

indicator light turns off.

PRO filters, as unit will not function with other

PRO