CALEFFI 5495 SEP4 Інструкції з монтажу, введення в експлуатацію та обслуговування - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкції з монтажу, введення в експлуатацію та обслуговування для Системи фільтрації води CALEFFI 5495 SEP4. CALEFFI 5495 SEP4 4 сторінки. 4-in-1 hydraulic, air, dirt and magnetic separator, ansi flanged
Також для CALEFFI 5495 SEP4: Посібник (16 сторінок), Інструкції з монтажу, введення в експлуатацію та обслуговування (4 сторінок)
Procedure for installation and insulation assembly (only for
2" to 4" sizes)
1. Remove the two black head covers at the ends.
2. Open the two side sections and the lower cap.
3. Install the separator in the system.
4. For cooling applications, consider using a silicon caulk
or sealant by spreading a thin layer of sealant over
the shell mating surfaces.
5. Reassemble the two side sections, fitting the lower cap
into one of the two sections and then connecting the other.
6. Complete with the two black head covers.
7. Install the automatic air vent and the drain valve.
Isolating the air vent valve
The air vent (A), replacement part number 501502A, is isolated
manually, using a shut-off ball valve (B), replacement part number
NA39589.
Dirt removing element
The SEP4™ dirt removing element separates
and collects any impurities present in
the system.
Ferrous impurities removal element
The SEP4™ ferrous impurities removing ele-
ment is a flexible magnetic stack inside a
brass dry-well probe (three for the 8 to 14 inch
size SEP4™) just below the flow stream in the
lower body. The probe(s) attracts and holds
the magnetite in the lower body and is flushed
by unscrewing the magnetic probe(s) and slowly pulling it out of
the dry-well and purging through the open drain valve- aided by the
system pressure.
CAUTION: Corrosion or leakage can cause damage or injury.
Periodically inspect for signs of corrosion or leakage. If corrosion or
leakage is note, the vent must be replaced. Failure to follow these
instructions could result in property damage and/or personal injury.
Service Instructions
There is no service required for the SEP4™ combination hydraulic, air, dirt, and magnetic separator.
Scan to view
·
Installation Tip
Leave this manual for the user.
C
Caleffi North America, Inc.
3883 W. Milwaukee Road
Milwaukee, WI 53208
T: 414.238.2360 F: 414.238.2366
10-19-18