Clarion APA250 Посібник користувача та інструкція зі встановлення - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник користувача та інструкція зі встановлення для Підсилювач Clarion APA250. Clarion APA250 17 сторінок. Apa amplifiers
Також для Clarion APA250: Посібник користувача та інструкція зі встановлення (8 сторінок)
Друкувати сторінку
- 1. Introduction
- 2. Table of Contents
- 3. Description
- 4. Installation, Mountinglwiring Precautions
- 5. Input Connections and Audio Control
- 6. Connections for Power and Speakers
- 7. Applications
- 8. Setting the Gain, Crossover/Bass Boost
- 9. Final System Checks, Troubleshooting
- 10. Product Specs
- 11. Warranty Information
clarion
APA250145012001
SETTING THE GAIN
After completing the installation, follow these steps to set the Gain Control and then
perform the Final System Checks.
1. Tum the Gain Control all the way counter-clockwise.
2. Tum the vehicle's Ignition Switch to the ON position. Then tum the ON/OFF
Switch on the source unit to the ON position. Set all Tone or Equalization Controls to
"flat" positions and
turn
Loudness off.
3. Playa CD or Tape and set the Volume Control at 75% of full level.
NOTE: If the system uses an equalizer set all frequency controls to the "flat"
position.
4. Slowly increase the Gain Control. Stop when you hear a slight distortion of audio.
SETTING THE CROSSOVER
The Clarion amplifiers feature fully adjustable crossovers. To set the crossovers, fol-
low these steps:
1. Using the X-Over Mode Switch, select the desired mode: LP for Low Pass, HP for
High Pass or OFF for Full Range.
2. Using the Freq (Hz) Selection Control, select the desired frequency.
SETTING THE BASS BOOST
1. Initially set the Bass Boost control to its OFF position.
2. Listen to a variety of music styles (e.g., Rock, Rap, etc.) and switch the Bass Boost
control ON until a noticeable increase in low bass response is realized.
CAUTION: If you hear a "pop" (due to speaker over-excursion) adjust switch to
lower the Bass Boost to prevent speaker damage.
11