Direct IP Idis DC-D Series Посібник з монтажу - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник з монтажу для Камера спостереження Direct IP Idis DC-D Series. Direct IP Idis DC-D Series 18 сторінок.
Також для Direct IP Idis DC-D Series: Посібник з монтажу (18 сторінок)

Друкувати сторінку

The following table describes the network cable

specifications.

Item

Content

Connector RJ-45

Ethernet

10/100 Base

UTP Category 5e or

Cable

higher

Maximum

100m

length

PoE

IEEE 802.3af, Class 2

• Wall/Ceiling Installation Hole

Used to screw the camera in place on a wall or a

ceiling.

• Cable Access Hole

For routing cables.

• Bottom Cover

Allows you to install the camera on a wall or a ceiling.

• IR LED

A sensor inside the system monitors lighting

levels and activates the IR LED during low-lighting

conditions.

• Factory Reset Button

Restores the camera's default factory settings. For

more information, refer to the Factory Reset.

• Status LED

Indicates the system's operating status. For more

information, refer to the LED Status Indications.

LED Status Indications

LED Status

Off

Status LED

Flashing

Note

10/100 Mbps

Description

Power not connected

Upgrading

Powered on

Factory Reset

Only use the factory reset button to restore the camera

to its factory default settings.

A factory reset will clear all camera settings configured

by the user.

Shut off the power supply.

Remove the dome cover.

Press and hold the reset button down

Hold the button down and apply the power.

Once the device turns back on, wait 5 seconds and

then release the reset button.

The device will go through the resetting process and

reboot. All camera settings will be restored to their

factory defaults after the reboot.

It's also possible to do a factory reset by pressing and

releasing the reset button while the camera is turned

on or using the IDIS Discovery program from a remote

location. A factory reset will reboot the system. For more

information on factory reset, refer to the IDIS Discovery

operation manual.

Part 1 – Introduction