Xerox 2000 Series Посібник з експлуатації - Сторінка 33
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Принтер Xerox 2000 Series. Xerox 2000 Series 36 сторінок. 2000 series nps/ips extension operations guide
Друкувати сторінкуMode switching problems
Condition
Does not boot from
EPS to NPS/IPS print
mode.
Information to have when calling for service
NPS/IPS Extension Operations Guide
4.
Problem solving
This chapter describes how to solve some specific problems that
may occur when you are using switching from one mode to
another.
Use the following information if you experience problems when
switching print modes.
Table 4-1. Mode switching problems
Possible causes
External rigid disk drive is not
powered ON (LED on the right front
of the external disk drive is not
illuminated).
SCSI cable between external rigid
disk drive and processor is not
properly connected.
In the United States, if you are unable to correct the problem, call
the following number:
1-800-822-2979
For customers outside the United States, call your local service
representative. A model-specific phone number is attached to
your printer at installation time.
Before you call, make note of the following:
•
Status code numbers and messages that appear on the
controller screen and the printer console
•
Indicator lights that are lit
Corrective actions
Ensure that the drive is plugged into
the power strip at the rear of the
controller stand.
Ensure that the SCSI cable is
connected to the single-ended SCSI
connector on the rear of the
processor unit.
4-1