Xerox 4250 - WorkCentre - Copier Посібник з швидкого використання - Сторінка 37

Переглянути онлайн або завантажити pdf Посібник з швидкого використання для Принтер Xerox 4250 - WorkCentre - Copier. Xerox 4250 - WorkCentre - Copier 42 сторінки. A4 black and white multifunction system
Також для Xerox 4250 - WorkCentre - Copier: Особливості (1 сторінок), Технічні характеристики (8 сторінок), Посібник для оцінювачів (16 сторінок), Додатковий посібник (1 сторінок), Брошура та технічні характеристики (4 сторінок), Посібник для оцінювачів (16 сторінок), Технічні характеристики (4 сторінок), Безпечне встановлення та експлуатація (4 сторінок), Посібник з експлуатації (13 сторінок)

Друкувати сторінку
Xerox 4250 - WorkCentre - Copier Посібник з швидкого використання

Troubleshooting

A variety of situations can effect the quality of your output. For optimal performance,
ensure the guidelines in the User Guide are followed. The documentation and the
fault messages on the machine help you to locate and resolve a problem easily.
Some problems can be resolved by switching off and switching on your device. Wait
approximately 20 seconds before switching the machine ON. If after rebooting your
machine the problem has not been resolved, have a look at some of the areas below
to identify solutions.
Problem
The machine will not
power on
Documents will not
feed through the
Document
Feeder
The machine will not
print from a
workstation
Cannot send an
E-mail
Paper jams
Cannot fax a
document
quick use guide
• Check to see that the machine is not in Low Power Mode as
indicated by the green light on the Control Panel. Touch the
User Interface screen to re-activate.
• Check to see that the power cord is correctly installed.
• Press the ON/OFF button to ON (I).
• Ensure that all staples or paper clips have been removed from the
originals.
• Ensure the document feeder is not overloaded. Max. 100
documents.
• Ensure that the edge guides are adjusted to touch the sides of the
originals.
• Make sure that an active network cable is connected to the work-
station.
• Check that the Network Setup is correct. Refer to Connecting to the
Network on page 10.
• Check if the machine is connected on the network as a printer.
• Check that E-mail is enabled. Refer to E-mail Setup on page 13.
• Load the paper in the paper trays with the seam side of the paper
up.
• Load the paper in the Bypass Tray with the seam side down.
• If the paper curls excessively, flip the paper over in the applicable
paper tray.
• Use paper from a fresh package.
• Ensure your machine is connected to a working telephone line and
check for a dial tone.
• Check that Fax is enabled. Refer to Fax Setup on page 15.
Solution
33