Xerox AS/400 Посібник зі встановлення та налаштування - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник зі встановлення та налаштування для Принтер Xerox AS/400. Xerox AS/400 23 сторінки. Power systems workstation customization object

Друкувати сторінку

Restoring the XTOOLSxxxx Save File to a Library

The following procedure requires that your user profile have save system authority (*SAVSYS) to restore the

library. The authorities *ALLOBJ, *SPLCTL, and *IOSYSCFG are required to run the commands provided in

XTOOLSxxxx, unless the administrator has made those commands public.

On the AS/400 command line, enter the following to create a save file in library QGPL, then press Enter:

1. CRTSAVF QGPL/XTOOLSxxxx

2. Open a W indows command prompt. Start an FTP session then type PW D to verify QGPL is your current

library. If not, change the current library to QGPL. FTP the library XTOOLSxxxx you retrieved from the zip file

to the save file QGPL/XTOOLSxxxx you created in step 1. You must set the FTP upload file type to BINARY.

ftp>put XTOOLSxxxx XTOOLSxxxx

3. On the AS/400 command line, enter the following to restore the library XTOOLSxxxx:

RSTLIB SAVLIB(XTOOLSxxxx) DEV(*SAVF) SAVF(QGPL/XTOOLSxxxx)

4. Add XTOOLSxxxx to your library list:

ADDLIBLE XTOOLSxxxx

Compiling a WSCO

Note: To access online help for each command, enter the command and press the Help (F1) key. To access

context sensitive help, enter the command on the command line and press the Prompt key (F4), then place the

cursor on a parameter and press Help (F1).

The process to create a WSCO requires that the source from the XTOOLSxxxx library is compiled for your

AS/400 release. Use the command CRTXWSC to compile the WSCO and place the compiled file in the

XTOOLSxxxx library.

1. Verify that XTOOLSxxxx is in your library list:

DSPLIBL

2. Type CRTXWSC on the command line and press F4 to compile the WSCO for the device(s) you wish to test.

3. Enter the information below and press the ENTER key.

Name of Work Station Cust Obj: A user-defined name that identifies the Xerox device. This will be the name

of the compiled WSCO. Press F4 for a list of WSCOs in the specified library that have already been compiled.

Library Name: Name of the library where the compiled W SCO is to be saved. It is recommended to

store the compiled W SCO in the same library as the source.

Source Member: The name of the WSCO that corresponds to the Xerox device for which this W SCO will be

created. For choices, consult the WSCO column in the table in section "Mapping Paper Trays from AS/400 to

PCL" later in this document. Press F4 for a list of available Xerox WSCOs.

Source File: Enter QTXTSRC as shown in the sample screen above.

Library Name: Enter XTOOLSxxxx as shown in the sample screen above. Change xxxx to match the

version of the library that was downloaded.

dc05cc0371