Xerox PHASER 8560MFP Додатковий посібник - Сторінка 4

Scanner Calibration Instructions

Perform the scanner calibration procedure if your scanner, document feeder, or document cover is

replaced. Scanner calibration adjusts the output quality of the front and back pages of 2-sided originals in

relation to each other. This procedure should not be performed as part of normal system operation.

Calibrate the scanner using the Scanner Calibration page that came with your

replacement scanner, document feeder, or document cover. After you begin the

calibration procedure at the control panel, calibrate the scanner using a two-step

process:

■

The first step scans the calibration page from the document glass. Follow the

steps in the Document Glass section. (For systems without a document

feeder, only use the steps in this section to calibrate the scanner.)

■

The second step scans the calibration page through the document feeder.

Follow the steps in the Document Feeder section.

Starting the Calibration Procedure

1. On the control panel, press the System button.

2. Select

, and then press the OK button.

Information

3. Select

Troubleshooting

4. Select

Service Tools

5. Select

Calibrate Scanner

Document Glass

1. Place the Scanner Calibration page on the document glass, with the top edge of the page toward the

left.

Note: Make sure the calibration page is aligned correctly. If the page is misaligned, the calibration

procedure will fail.

, and then press the OK button.

, and then press the OK button. Continue with the Document Glass steps.

Phaser

www.xerox.com/office/8510_8560support

1 of 2

8510/8560MFP

075-1018-00 Rev A