Xerox XEScan Посібник з монтажу - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з монтажу для Принтер Xerox XEScan. Xerox XEScan 21 сторінка.

2. Install the FireBoard 400 and Dongle

Before removing the cover, disconnect any power cord connected to the computer.

CAUTION: When working with the electronic components in the computer, always wear an electrostatic

discharge wristband that is attached to an exposed metal section of the computer.

Note: If the operating system is Windows NT 4.0, disable the Plug-and-Play setting in the PC BIOS. In

addition, for Windows NT and 2000, the installer must have Administrator privileges.

1. Power off the PC to which the scanner will be connected.

2. Remove all external cables and place the PC on a sturdy level surface.

3. Remove the PC cover.

Note:

Refer to Appendix B: Opening Your PC if there are questions about how to open the cover

or locating a PCI slot.

4. Remove a slot cover corresponding to an empty PCI bus slot.

5. Insert the FireBoard into the empty PCI bus slot.

6. Fasten the FireBoard with the screw used to secure the slot cover.

7. Reinstall the PC cover and re-connect the existing cables for the PC.

Caution: Take care that no cables are pinched or unplugged when installing the cover.

WARNING

Inserting the FireBoard into the PC.

XEScan Solution Installation Guide