Xerox 3100MFPX - Phaser B/W Laser Інструкція з експлуатації - Сторінка 32
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Принтер "Все в одному Xerox 3100MFPX - Phaser B/W Laser. Xerox 3100MFPX - Phaser B/W Laser 36 сторінок. Dect phone installation instructions
Також для Xerox 3100MFPX - Phaser B/W Laser: Посібник користувача (2 сторінок), Посібник для оцінювачів (12 сторінок), Інструкція з монтажу (2 сторінок)
Друкувати сторінку
S
ETTINGS
During the registration process (up to
one minute), the LCD screen displays
HANDSET
REGISTRATION
message disappears once registration is
complete.
If the registration process fails (for
example, the handset left the
registration mode too soon), the
machine emits a 3-beep signal. In
this case, repeat the procedure from
step 1.
The new handset and the base are mutually
searching for each other. The registration
may take several seconds.
Once the handset is registered, the handset
automatically exits the registration mode and
lets you know the registration is done.
You can also set your base to the
registration mode using a handset
already registered by selecting the
Registration function in the menu
SETTINGS/ADVENCED SET./SET
BASE.
B
ASE SETTINGS
.
The
Using a handset to put the base
in registration mode
This function enables you to put the base in
registration mode so you can register a new
handset. To do so, the handset to be
registered must be in registration mode (refer
to paragraph Registering a new handset to
a terminal, page 30).
On the navigator key
until the SETTINGS screen is displayed,
press OK to confirm.
Select ADVANCED SET. using
Press Valid.
Select SET BASE using
Valid.
Select REGISTR. MODE using
Press Valid.
A screen prompts you to confirm the setting
of the base to the registration mode. Press
Yes
indicator light on your base starts to quickly
blink green.
Your base will remain in registration mode for
about 1 minute.
33
(
TERMINAL
, press
.
.
.
to enter the registration mode. The
)
or
or
.
or
. Press
or
.