Direct power BC185J Посібник з техніки безпеки та експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з техніки безпеки та експлуатації для Пила. Direct power BC185J. Direct power BC185J 17 сторінок. 7 1/4" circular saw
Друкувати сторінку-Work with approved safety equipment, such as those dust masks that are specially
designed to filter microscopic particles.
ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR CIRCULAR
SAW
1.If the supply cord is damaged have it replaced by a qualified person.
2.Do not use blades which are deformed or cracked.
3.Do not use saw blades made of high speed steel.
4.Do not use blades which do not comply with the characteristics specified in these
instructions.
5.Do not stop the blade by lateral pressure on the disc.
6.Ensure that movable guards operate freely without jamming.
7.Do not lock the guard in the open position.
8.Ensure that any-retraction mechanism of the guard system operates correctly.
9.Characteristics of saw blades. Take carful note of blade thickness & diameter and
ensure it is suitable for the circular saw.
10.Do not use saw blades, the body of which is thicker, or the set of which is smaller
than the thickness of the riving knife.
11.Ensure that the riving knife is adjusted so that the distance between the riving knife
and the toothed rim of the saw blade is not more than 5mm.The toothed rim does not
extend more than 5mm beyond the lower end of the riving knife.The riving knife should
always be used except when plunging in the middle of the work piece.
12.For circular saws for woodworking it is advised that if used in confined areas dust
protection or separate dust collection system should be used.
13. Always use the appropriate safety equipment that is required for the product. e.g.
Goggles / Safety Spectacles, Ear defenders (essential with tools with a noise rating of
over 85 dbA), Gloves and face masks. In all cases ensure that the safety equipment is
in good condition.
Double insulation:
The tool is double insulated.This means that all the external metal parts are electrically
insulated from the mains power supply. This is done by placing insulation barriers
between the electrical and mechanical components making it unnecessary for the tool
to be earthed.
Important note:
Ensure your mains supply voltage is the same as your tool rating plate voltage. Remove
the mains plug from socket before carrying out any adjustment or servicing.
SYMBOLS
Read the manual
Wear dust mask,eye & ear protection
Warning
Wear gloves