Xerox DC240 - DocuColor 240 Color Laser Примітка до випуску - Сторінка 15

Переглянути онлайн або завантажити pdf Примітка до випуску для Ксерокс. Xerox DC240 - DocuColor 240 Color Laser. Xerox DC240 - DocuColor 240 Color Laser 34 сторінки. Overview of the control panel buttons.
Також для Xerox DC240 - DocuColor 240 Color Laser: Посібник із швидкого старту (2 сторінок), Посібник із заміни обладнання (2 сторінок), Посібник із швидкого старту (2 сторінок)

Page 15

Custom page size

When you specify a custom page size in the Windows printer drivers, make sure the custom

size matches the page size speciﬁed in your application. If the page sizes do not match, the

custom page size may not print correctly.

You can print to a custom page size from Tray 1, Tray 2, or Tray 5 (Bypass). For Tray 1

or Tray 2, set the page dimensions at the copier in Setup > Paper Tray Attributes. If the

document you must print has a page size of 220

297 mm, for example, set

=220 and

=297. For Tray 5 (Bypass), load the paper so that the short end of the page feeds into the

copier. Note that the message that prompts you to load paper has the dimensions reversed

(297

220 instead of 220

297).

All custom page sizes sent to the DocuColor 250/240 must be created SEF (Short Edge Feed).

Paper Source set to Auto Select

If you print a job with Auto Select as the paper source, the copier uses any of the Trays 1- 4,

or Tray 6. It does not use Tray 5, which is the Bypass Tray.

Printing from Tray 5 disregards media settings of job

If you print a job with Tray 5 (Bypass) as the paper source, the job is printed on the paper

loaded in Tray 5, even if the paper does not match the job's settings for page size, media type,

and media quality. However, the copier prints the job according to the job's settings, not the

actual paper used. Be sure to load paper that matches the job's settings.

Page Range

You cannot access the Page Range option from the printer driver. Use the application page

range option or change the setting for this option from Command WorkStation or Spooler.

Watermarks, Negative Image, and Print Page Borders

The Negative Image print option is not available in Windows printer drivers. The

Watermarks and Print Page Borders print options are not available in the Windows

PostScript printer drivers.

These print options are available under Page Setup in Mac OS 9 and Mac OS X Classic.

Layout and Print Page Borders

If you print an N-up job, where N is greater than 1, from the PCL printer driver, you can

control whether the borders of the pages are printed through the Print Page Borders option.

If you print from the PostScript printer driver, page borders are always printed.

Stapler Mode and Punch Position

Stapling and punching require that a ﬁnisher is installed on the copier. The ﬁnisher type

determines the number of holes (2, 3, or 4) punched.

Part Number: 45045321