Xerox DocuColor 40 Посібник з налаштування - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з налаштування для Аксесуари для принтерів Xerox DocuColor 40. Xerox DocuColor 40 8 сторінок. High speed paper-backed transparencies
Також для Xerox DocuColor 40: Посібник з використання (12 сторінок), Довідковий посібник (13 сторінок), Посібник з налаштування (4 сторінок), Додатковий посібник (17 сторінок), Інструкція по застосуванню (1 сторінок)

Printing

Print Speed / System Performance

The Splash DC Series v4.0 server has 512Mb of frame buffer memory and 256Mb of pipeline buffer.

The maximum print speed for the Splash DC Series v4.0 system is limited by the print speed of the DocuColor

40/30 Pro Digital Color Copier / Printer.

Splash DC Series v4.0 is a full document printer; therefore, the print engine may not cycle up until the entire job

is ready to print. The copier may cycle down between each job depending on job complexity.

Overall system performance ("Click to Clunk" time) is primarily dependent upon the software applications and

network environment being used. Rasterizing (RIP-ing) is only a small fraction of "Click to Clunk" time.

Printing with custom software applications may produce unexpected or unknown results.

Printing Resolution

For all paper sizes, full resolution and full color depth is available (400 x 400 x 8).

Billing Meters

Splash DC Series v4.0 provides accurate billing of all color and black & white images in black detection mode.

When black detection is enabled, productivity may be affected when the copier/printer changes from black to full

color mix or from full color mix to black.

Maximum Image Sizes

The maximum image size from an application is limited by the maximum image size produced by the DocuColor

40/30 Pro.

The maximum image size of the DocuColor 40/30 Pro in the printer mode is: 11.69 inch 0.5% x 17.13 inch

0.5% (291mm 0.5% x 426.5mm 0.5%)

The application and the DocuColor 40/30 Pro setup control image position.

IOT Specification

DocuColor 40/30 Pro must have 4.7 firmware or higher.

Printer Driver Support

Xerox, if necessary, supplies PPD upgrades

Adobe Level 2 for Windows 3.x

Adobe 4.2 for Windows 95/98

Windows NT 3.5 and 4.0 (custom drivers for NT are not provided. Only Microsoft PPDs are supplied)

Adobe PSPrinter 8.5 for Macintosh (PPDs support earlier versions of the LaserWriter 8 driver (LW8.3 and 8.4)

Support for UNIX will be via Xinet

No driver support for DOS applications

Terms and product names used in this document may be trademarks or registered trademarks of their respective companies and are hereby acknowledged.

Launch Version

Page 3 of 8

Expectation Setting Document for

Splash DC Series v4.0

Digital Front End for DocuColor 40/30 Pro

701P99809

18 March 1999

40_ced-s.doc