Xerox 850DX - Phaser Color Solid Ink Printer Примітка до випуску - Сторінка 16

Переглянути онлайн або завантажити pdf Примітка до випуску для Програмне забезпечення Xerox 850DX - Phaser Color Solid Ink Printer. Xerox 850DX - Phaser Color Solid Ink Printer 33 сторінки. Installation guide for accxes 10.2
Також для Xerox 850DX - Phaser Color Solid Ink Printer: Технічні характеристики (2 сторінок), Посібник оператора (16 сторінок), Додатковий посібник (1 сторінок), Додатковий посібник (11 сторінок), Посібник з налаштування (1 сторінок), Інструкція з очищення Посібник з очищення (9 сторінок), Додатковий посібник (26 сторінок), Примітка до випуску (11 сторінок), Примітка до випуску (11 сторінок), Інструкція з монтажу (2 сторінок)

8.1.1.4

USING IMMEDIATE IMAGE OVERWRITE (IIO)

The Immediate Image Overwrite (IIO) feature is designed to keep the system clean while it is

being used. The status of the feature is displayed on the "Security" page as shown below by the

solid circle. To enable or disable the feature simply press the button highlighted by the dashed

circle on the page below.

To ensure that the hard drive is clean and remains clean, it is recommended that IIO be enabled

and then an ODIO be performed. Certain configuration changes (enabling of scanner, postscript,

scan-to-net etc) result in repartitioning of the hard drive, which could result in non-image

partitions occupying sectors that were previously imaged, or verse visa. It is recommended that

the hard drive be clean (running IIO, or by performing an ODIO) prior to the configuration change

and then be cleaned by performing an ODIO after the configuration change. If the hard drive is

not clean prior to the configuration change it is possible that a section of the hard drive containing

image data could end up in a non-image partition and will not be cleaned by an ODIO. If an

ODIO is not performed after the configuration change, than any sectors from non-imaged

partitions which are now in image containing partitions will look dirty because they do not contain

the required pattern.

When IIO is enabled, each print or copy image is overwritten after it is printed and the scan-to-net

images are overwritten after they are deleted from the controller. This operation happens without

any significant delay in processing and printing of jobs. The one exception is that deleting large

scanned jobs may take a few minutes to free up the disk space so that it can be used again.

While IIO is enabled, the controller will keep the HDD clean. If the controller is rebooted during

the processing of a job, it will clean the partitions on which the job was stored before it completes

it boot-up sequence. This may take as long as an ODIO depending on what type of jobs were

being processed.

Additionally, two features (raster stamps, and image recall) are disabled when IIO is enabled.

When IIO is enabled raster stamps are rejected and an error page is printed with the message

Page 16