Xerox Synergix 8850 Посібник з програмного забезпечення - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з програмного забезпечення для Програмне забезпечення Xerox Synergix 8850. Xerox Synergix 8850 30 сторінок. Windows nt 4.0 postscript print driver user guide
Також для Xerox Synergix 8850: Посібник з налаштування (20 сторінок), Примітка до випуску (23 сторінок), Примітка до випуску (8 сторінок), Посібник з навчання клієнтів (50 сторінок)

Introduction

The purpose of this Guide is to assist you with instructions for installing a

PostScript Print Driver, adjusting the Print Driver's settings to meet your

needs, printing with the Print Driver, and removing the driver when it is no

longer needed.

Electronic copies of this Guide are available on the Internet at www.xes.com.

A Workstation running Windows NT 4.0 with Service Pack 3, or higher,

installed.

A Working Knowledge of your Workstation's Operating System.

Appropriate Cabling connecting your workstation to the network or directly

to the printer's AccXES Controller.

Appropriate protocols and ports enabled on both the printer and

workstation, with a connection established through the network or directly

between the printer and your workstation.

1. Read "Before You Start" for valuable information on checking the

status of your communication protocols and creating a new printer port

for use with the PostScript Driver.

2. Install the driver on your workstation as stated in the Driver

Installation section of this Guide.

3. Configure the driver settings to meet your needs as stated in the

Driver Configuration section of this Guide.

XES Synergix 8825/8830/8850/8855 Windows NT 4.0 PostScript Print Driver User Guide

4. Click OK on the Print Screen to print your job.

5. If you no longer need the driver, remove the driver as stated in the

Removing the Driver section of this Guide.