Xerox M Series Картка початкового налаштування

Переглянути онлайн або завантажити pdf Картка початкового налаштування для Сервер друку Xerox M Series. Xerox M Series 2 сторінки.

Друкувати сторінку

M Series

Version 1.0

Initial Setup Card

The setup of the M Series Print Server is not complete until you have followed the

Pre-Installation

Step 1:

Prepare the

Copier

Step 2:

Prepare the M

Series

Step 3:

Connect the

cables

Step 4:

Configure the

M Series for

your Copier

Step 5:

Configure the

M Series for

your Network

Initial Setup Card

Welcome to the family of productive M Series users!

You will soon have the power of M Series print server at your fingertips. The M Series is

very easy to set up and use. This Setup Card guides you through the initial set up process.

Follow this process each time you set up the M Series print server in a different location,

connect it to a different network, or connect it to a different color copier.

After you complete the initial setup process, refer to the M Series Getting Started Guide for

instructions for configuring and connecting the M Series to you network.

instructions on this card and in the Getting Started Guide!

Contact your Xerox representative to have a Port Kit installed on your copier.

Ensure that there is at least 25 sheets of letter size (8.5"x11") paper in one of the copier's paper

trays. Make a copy off the glass to ensure that the copier is functioning properly. After the copy

turn off the copier

is made,

Unpack the M Series and place it near the copier.

Open the accessory box and remove the cables.

Open the disk set labelled

Connect the M Series to the copier using the cable provided.

Connect the power cable to the M Series and plug it into an outlet. This outlet should not be on

the same power circuit as the copier's outlet.

After you have connected all the cables,

From the Setup Disk package, select the

When the copier is up and be at a ready state,

As the print server powers up, the following sequence of events occur:

1. The green led illuminates, indicating that power is on.

2. The print server emits one long and two short beeps.

3. After about 30 to 45 seconds, the green activity light on the floppy drive illuminates briefly

and the print server emits one short beep.

4. After about 45 seconds, the print server emits six beeps; two short, two long, and two

short. This is a signal from the print server indicating that it is ready to accept the

Configuration

Disk.

Inserted the

Copier Configuration Disk

within 5 seconds after you hear the series of two short, two long, and

two short beeps.

The status indicator alternately flashes between yellow and red several times then changes to

flashing yellow. After a short time, the M Series prints a Startup test page.

Turn off the M Series print server.

To configure the print server for your network, take the

network administrator and have the administrator edit the disk so that it includes the print

server network parameters. Instructions are in the M Series Getting Started Guide.

QA 25 Draft: July 31, 1998

Setup

Disks.

turn on the copier

Copier Configuration Disk

turn on the M Series print server.

in the print server floppy drive

for your copier model.

Copier Configuration Disk

Copier

to your

9204000