Alderon Industries VersAlarm 4X Посібник з експлуатації, технічного обслуговування та монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з експлуатації, технічного обслуговування та монтажу для Система безпеки Alderon Industries VersAlarm 4X. Alderon Industries VersAlarm 4X 6 сторінок. 2-zone outdoor
Також для Alderon Industries VersAlarm 4X: Посібник з експлуатації, технічного обслуговування та монтажу (3 сторінок)

Друкувати сторінку

VersAlarm

2-Zone | Outdoor Alarm System, Type 4X

Operation, Maintenance and Installation Manual

Wiring - Terminal Block and Wago Connectors

1. The wiring diagram (Fig. 6) shows 12 terminals on the circuit board that

consists of six pairs of connections. Starting from the top, terminals are

included for: incoming power, alarm buzzer, zone-1 auxiliary contacts,

zone-1 sensor (signaling device), zone-2 auxiliary contacts, and zone-2

sensor (signaling device). The incoming power should be on a separate

circuit breaker from any other device and not on a switched receptacle

to maintain power integrity.

6A = Incoming Power; L1 and L2/N (voltage depends on model)

6B = Alarm Buzzer; "+" and "−"

6C = Zone-1 Auxiliary "Dry" Alarm Contacts

6D = Zone-1 Sensor (signaling device)

6E = Zone-2 Auxiliary "Dry" Alarm Contacts

6F = Zone-2 Sensor (signaling device)

CAUTION: Do not connect incoming power to the alarm panel until all steps of the

installation are complete and the system is ready for testing.

2. The line connections from the incoming power are terminated into the

respective Wago connectors/terminals (Fig. 6A). Voltage depends on

model, 120VAC = L1 and N or 240VAC = L1 and L2.

3. The alarm buzzer is factory wired from the circuit board terminals to the

buzzer inside the alarm panel enclosure (Fig. 6B).

4. If connecting to an alarm security system or building automation system

(BAS), use 18 gauge 2-conductor wire to connect to the auxiliary

contact terminals on the circuit board for zone-1 (Fig. 6C, AUX1) and

zone-2 (Fig. 6E, AUX2).

5. The sensors (signaling device) are connected to the alarm terminals on

the circuit board for zone-1 (Fig. 6D, ALM1) and zone-2 (Fig. 6F, ALM2).

6. NEVER leave ground wire exposed inside the panel, use provided

Wago connector for ground termination.

Note: Push the orange button on the terminal block with a small screwdriver or

pointed object to "release" the terminal to install or uninstall a wire.

Alarm Systems

Control Panels

Alderon Industries - Hawley, MN | 218.483.3034 | [email protected] | alderonind.com

™

Float Switches

Leak Detection Systems

(Fig. 6)

Incoming Power

L2/N

Alarm Buzzer

–

Zone-1

Auxiliary Contacts

Zone-1

Signaling Device

Zone-2

Auxiliary Contacts

Zone-2

Signaling Device

Factory Wired

Field Wired

Factory Wired

Field Wired

P/N: QSG00307_Rev01

Factory Wired

Field Wired

L2/N

Page 4 of 6