Alderon Industries VersAlarm I/O VLIO-00005 Посібник із швидкого старту

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Система безпеки Alderon Industries VersAlarm I/O VLIO-00005. Alderon Industries VersAlarm I/O VLIO-00005 2 сторінки. Indoor/outdoor alarm panel
Також для Alderon Industries VersAlarm I/O VLIO-00005: Посібник користувача (20 сторінок)

Друкувати сторінку

VersAlarm

Indoor/Outdoor Alarm Panel | Model: VLIO-00005

QUICK START GUIDE

Step 2: Mount Enclosure

Determine the mounting location

for the VersAlarm™ I/O. Make

sure the power outlet is within

six feet of the alarm panel for the

pre-installed power cable. Hold the

VersAlarm™ I/O up to the desired

mounting location, mark the drill

hole locations. Once marked, drill

pilot holes for screws (not includ-

ed) and use wall mount anchors

(not included) if necessary. Place

enclosure in the mounting location,

adjust until the pilot holes are lined

up with the enclosure and fasten

screws to secure the alarm panel

in place.

Step 3: Power Cable and Float Switch

The alarm panel comes with a

pre-installed power cable and

alarm float switch. Refer to the

instructions for the alarm float

switch to determine the alarm

activation level and for proper

installation. If using the auxiliary

contacts, see step 4 for wiring.

CAUTION: Do not connect power until

installation/wiring is complete.

Mount alarm float switch

at alarm activation level

I/O

™

Plug power cable into

230VAC receptacle

Safety Guidelines

Before proceeding with the installation or operation of this product,

read all instructions thoroughly, as well as complying with all federal,

state and local codes, regulations, and practices. This product must

be installed by qualified personnel familiar with all applicable local

electrical and mechanical codes. Refer to the National Electrical Code

(NFPA 70). Failure to properly install and test this product can result in

personal injury or equipment malfunction.

Step 1: Remove Bottom Cover

Remove the bottom enclosure cover screw, slide directly downward

until the sound chamber is cleared (1A) and pull directly away (1B).

Step 4: Wiring

The diagram below shows the six terminals on the terminal block that

consists of three pairs of connections.

1) The pre-installed power cable is connected to terminals 5 and 6,

first line (L1) in terminal 5 and second line (L2) in terminal 6.

2) The pre-installed float switch is connected to terminals 3 and 4.

3) Installing an auxiliary device to terminals 1 and 2 is optional.

4) NEVER leave ground wire exposed inside the panel, use provided

Wago connector for wire termination.

AUX

SENSOR

Installing Wire into Wago Connector:

1) Lift tab(s) upward.

2) Insert wire(s) into slot.

3) Press tab(s) downward.

4) Make sure wire(s) are secured.

WARNING

POWER

TO OPEN

TO CLOSE

WAGO