Alderon Industries Wireless Versa'larm VA01B Посібник з експлуатації, технічного обслуговування та монтажу - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник з експлуатації, технічного обслуговування та монтажу для Система безпеки Alderon Industries Wireless Versa'larm VA01B. Alderon Industries Wireless Versa'larm VA01B 6 сторінок. 1-zone alarm
Друкувати сторінку
Wireless Versa'larm
™
1-Zone Alarm - Model VA01B
Part Numbers - 7991 and 7992
Operation, Maintenance and Installation Manual
Installation of the Alarm Panel and Wireless Receiver Continued
3. Determine the mounting location for the alarm panel and wireless receiver. Make sure power outlet (120 VAC, 50/60 Hz)
is within 5-feet of the alarm panel (Fig. 8). The power outlet should be on a separate circuit breaker from any other device
and not on a switched receptacle to maintain power integrity. Mount the alarm panel and wireless receiver using two #6
self-tapping screws (not included/Fig. 9) for both devices. Use two #8 plastic anchors (not included/Fig. 10) for both devices
if mounting the alarm panel and wireless receiver to sheet rock.
(Fig. 8)
(Fig. 9)
5 ft. Max
(Fig. 10)
4. To install/replace the battery for the backup power feature, remove the access cover (Fig. 11) and install 9 VDC battery
(Duracell model MX 1604B2 / Fig. 12). After installing battery, the green power LED should illuminate, then press and hold
the "Alarm Test" pushbutton (Fig. 13) to activate the alarm and make sure the battery is working properly. The buzzer should
annunciate and the alarm LED should illuminate. If using the auxiliary contacts, leave the access cover off until step 5 is
completed. If the auxiliary contacts are not used, replace the access cover (Fig. 14).
(Fig. 11)
(Fig. 12)
(Fig. 13)
(Fig. 14)
Alarm Systems
Control Panels
Float Switches
Leak Detection Systems
P/N: 101985
Page 5 of 6
Alderon Industries - Hawley, MN | 218.483.3034 | [email protected] | alderonind.com