Alderon Industries Mini Power Post MPMS-0001 Посібник

Переглянути онлайн або завантажити pdf Посібник для Вимірювальні прилади Alderon Industries Mini Power Post MPMS-0001. Alderon Industries Mini Power Post MPMS-0001 4 сторінки.

Друкувати сторінку

Mini Power Post

™

Pump Connection Center | Demand Dose

15 Amp, 120/240VAC | Models: MPMS-0001 and MPMS-0002

Alderon Industries™ | Patent Pending

QUICK START GUIDE

Step 2: Remove Bottom Cover

Remove the bottom enclosure cover screw, slide directly downward

until the sound chamber is cleared (2A) and pull directly away (2B).

Step 3: Remove / Install Post Cap

Remove Post Cap:

1) Remove Screws and Lift Cap Upwards

Install Post Cap:

1) Position text FRONT (with arrows) Forward

3) Align Fastener Holes

4) Fasten Screws to Secure Cap to Post

Monitoring System

Safety Guidelines

Before proceeding with the installation or operation of this product,

read all instructions thoroughly, as well as complying with all federal,

state and local codes, regulations, and practices. This product must

be installed by qualified personnel familiar with all applicable local

electrical and mechanical codes. Refer to the National Electrical Code

(NFPA 70). Failure to properly install and test this product can result in

personal injury or equipment malfunction.

Step 1: Install Post

Determine location for the post in the

ground near a tank and drill access

holes for the float switch cables using

the customer supplied conduit/fittings or

Alderon's riser connection kit. Route the

cables through access holes and wire as

described in step 5. Run the direct burial

power wires underneath the bottom of

the post as shown in the diagram.

Note: Seal all conduits to prevent moisture and gases

from entering the post per local codes.

Direct

Burial

Wires

Step 4: Installing Wire into WAGO

Before making wire connections and terminations, carefully read this

step for proper functions of both types of WAGO connectors.

WARNING: Improper use of the connectors will cause damage, DO

NOT use mechanical tools to open or close, hand usage only.

Wire Termination - Splice Connector WAGO (Fig. 1):

1) Lift tab(s) upward.

2) Insert wire(s) into slot.

3) Press tab(s) downward.

4) Make sure wire(s) are secured.

Wire Connection - Quick Snap Terminal WAGO (Fig. 2):

1) Press tab(s) outward. DO NOT open past 40° angle

2) Insert wire(s) into slot.

3) Press tab(s) inward.

4) Make sure wire(s) are secured.

(Fig. 1)

TO OPEN

WAGO

TO CLOSE

WAGO

WARNING

(Fig. 2)

TO OPEN

WAGO

TO CLOSE

WAGO