Ecoological AeroBox Посібник з монтажу

Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільні аксесуари Ecoological AeroBox. Ecoological AeroBox 4 сторінки.

Друкувати сторінку

www.ecoological.com

Approximate installation time: 30-45 minutes, based on installer

• Center punch

• Drill

Standard AeroBox™, complete with door, (2) keyed cam locks, and load floor

Kit #1: All Assemblies – Wheels

• (2) Wheels

• (2) Axle bolts

• (2) Main door keys

Kit #3B: Standard Assembly – Rubber Feet

• (4) Rubber Feet

• (4) #6-32 X ¾ inch screws for rubber feet

• (4) #6-32 hex nuts and (4) #6 split washer

Kit #3C: Standard Assembly – Hardware

• (2) 5/16-18 x 2 in. thumb screws

• (2) 5/16-18 Nylock™ flanged nuts

• (2) Threaded rivet inserts

• (1) Threaded insert install tool

Read all instructions before installing or using this product. The AeroBox™ will fit most full-size truck beds

that have >58.5 inch tailgate opening, including liner thickness. Please view our helpful installation video and

FAQ's on our website, or call customer service at (844) 918-3688 if you have additional questions. Any

modification or unintended use of this product shall immediately void all manufacturer's warranties. The

manufacturer disclaims all liability for injuries to persons or property resulting from any modifications to,

unintended use, or improper assembly of this product.

1. Place AeroBox™ upside down on clean surface

2. Locate the threaded inserts in the wheel pocket

3. Insert the axle (wheel bolt) through the bearing on the

wheel and thread in to the threaded insert using ½ inch

wrench or socket until tight. Do not overtighten.

4. Repeat for remaining wheel.

1. While in upside down position, drill 9/64 inch hole at the center mark of each foot location

2. Position AeroBox™ with door side up

3. Insert #6 X ¾ inch machine screw through the bumper foot and through drilled hole.

4. Install split washer and nut on to screw by accessing through AeroBox™ door opening

5. Repeat for remaining bumper feet

Note: Rubber feet help keep AeroBox from sliding. In some cases, you may prefer to

leave off rubber feet for easier sliding.

www.ecoological.com

Installation Manual-Standard

-INSTALLATION TIME-

-TOOLS REQUIRED-

• Phillips screwdriver

• 5/16"-18 x 1.5" bolt and washer

-PARTS INCLUDED-

AEROBOX™ WHEEL INSTALLATION

RUBBER FEET INSTALLATION

10/2017

• 5/16" and 1/2" wrenches or sockets

• 9/64", 3/8", 1/2" drill bits

AB Standard Assembly 10-2017