Yamaha 501 Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Музичний інструмент Yamaha 501. Yamaha 501 24 сторінки. Internet connection guide (version 1.10)
Також для Yamaha 501: Посібник користувача (20 сторінок), Посібник з монтажу (32 сторінок), Посібник з підключення (22 сторінок)

Друкувати сторінку

Before making any connections, switch OFF the power to

the unit and the amplifier or other component.

Connections should be made to the correct input terminals

of the amplifier or other component.

Connection cord

(included)

Choose one of the ways listed below to connect this unit to your amplifier.

When the LINE OUT (analog) terminals of this

unit are used (

)

Be sure that the left ("L") and right ("R") LINE OUT terminals

are connected to the corresponding (left and right) terminals

of the amplifier or other component.

Connect the "LINE OUT" terminals to the "CD" (or "AUX")

terminals of the amplifier. If the amplifier does not have

such terminals, use the "TAPE PB" terminals. For additional

details concerning these connections, refer to the operation

instructions for the amplifier being used.

CDC-901 only

Adjust the level of signals output into an amplifier, etc. by

using the OUTPUT LEVEL buttons.

CONNECTIONS

LINE OUT

DIGITAL

AUDIO

OUT

OPTICAL

DIGITAL IN

If the placement of this unit causes noise to other

equipment, such as a tuner, separate them from each other.

To AC outlet

Optical fiber cable

(not included)

CDC-901 only

When the DIGITAL AUDIO OUT (OPTICAL)

terminal of this unit is used (

Before using this terminal, remove the terminal's cover by

pulling it.

Make the connection from this terminal to the optical input

terminal of an amplifier by using a commercially available

optical fiber cable.

* Use an optical fiber cable that conforms to EIAJ

standards. Other cables might not function correctly.

Be sure to attach the terminal's cover when this terminal is

not being used, in order to protect the terminal from dust.

Set the level of signals output into an amplifier to max. by

using the OUTPUT LEVEL buttons.

This terminal can also be connected to the optical input

terminal of a digital audio tape deck (DAT) etc. to record CD

onto tape directly.

CDC-501

CDC-901

Amplifier

)