Yamaha Acoustic Посібник користувача - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник користувача для Музичний інструмент Yamaha Acoustic. Yamaha Acoustic 35 сторінок. Yamaha acoustic guitar-accessory: supplementary guide
Також для Yamaha Acoustic: Посібник користувача (1 сторінок), Посібник з монтажу (11 сторінок), Додатковий посібник (32 сторінок)

Друкувати сторінку
Yamaha Acoustic Посібник користувача

Saving Patches

Storing edited patches (STORE)

The MAGICSTOMP lets you store your original patches in its User Patch memory (U01-U99). After
creating a patch you like, use the following procedure to store the patch.
* Patches can not be stored in the Preset Patch memory (P01-P99).
* The volume knob's setting is not stored with patch data.
The store operation takes your edited data and writes it to the destination patch number that you've
selected, overwriting the old patch data with the new. Depending upon your needs, either overwrite
the original patch with new data, or select another patch number to store the new data to.
To rewrite (overwrite) the original patch with new data
q
After you're done editing, press the [STORE/EXIT] button.
"PRESS[STORE]1sec" appears in the lower half of the display.
The destination patch number to which the patch will be stored, and the patch name (under
which the data will be stored) appears on the upper half of the display.
* If the [STORE/EXIT] button is pressed when a Preset Patch is currently selected, the corresponding User
Patch number is automatically selected as the destination patch number for storing.
w
You can also give the patch a new name.
To change the name of the patch, follow steps
e
Press and hold the [STORE/EXIT] button (about 1 second) until "NOW STOR-
ING..." appears on the display.
* To cancel the store operation, press and quickly release the [STORE/EXIT] button (within 1 second) and the
MAGICSTOMP returns to its original condition (the changed patch name returns to its original name).
Other than the patch name, any changes made to parameter data will be safe until another patch is selected.
To store the data to the file's original patch number (overwrite) and with the same
patch name, press and hold the [STORE/EXIT] button for more than 1 second to
execute the store operation after you're done editing.
* This store procedure can not be used when editing a Preset Patch. You must first assign a User Patch number
as the destination patch number before executing the store operation.
18
Destination patch
number for storing
w
r
through
Press and hold
The name of the
edited patch
described on page 20.
Store complete!