Yamaha Acoustic Посібник користувача - Сторінка 22

Переглянути онлайн або завантажити pdf Посібник користувача для Музичний інструмент Yamaha Acoustic. Yamaha Acoustic 35 сторінок. Yamaha acoustic guitar-accessory: supplementary guide
Також для Yamaha Acoustic: Посібник користувача (1 сторінок), Посібник з монтажу (11 сторінок), Додатковий посібник (32 сторінок)

Друкувати сторінку

Auto Feedback Reduction (AFR) Function

The MAGICSTOMP is equipped with a highly sophisticated Auto Feedback Reduction

function (AFR) to eliminate feedback (howling).

* In this case, "Feedback" is when a specific frequency produced by the amplifier causes the guitar to resonate

uncontrollably, creating a howling sound.

The MAGICSTOMP's AFR function uses a notch filter, which cuts the frequency that is

causing the feedback, to eliminate feedback. A maximum of five notch filters can be set

and operating at the same time.

How the –, AFR/ON/OFF, + Switches Function

The AFR function can only be active when the patch's

effect type is set to "AcousticMulti". If the AFR function is

switched ON, the

Switch operation as described below, will only result in

switching the patch ON/OFF if a patch using another ef-

fect type is selected, or the AFR function is switched OFF

(the

edit icon is displayed) even if the patch's effect type

is set to "AcousticMulti".

Using the AFR Function

The procedure required for switching the AFR function ON/OFF differs in the Up/Down Mode and in

the Performance Mode.

When feedback occurs in the Up/Down Mode press the AFR/ON/OFF switch,

and when in the Performance Mode press the switch that corresponds to the

currently selected patch (–, AFR/ON/OFF, +).

The MAGICSTOMP will automatically identify the frequency causing the feedback and activate

an unused notch filter. When the filter identifies the problem frequency, the display will appear

similar to that shown below and then return to its previous condition.

To indicate that the AFR function is active, the AFR/ON/OFF switch's lamp will flash when in the

Up/Down Mode, while in the Performance mode, the switch's lamp (–, AFR/ON/OFF, +) for the

currently selected patch will flash.

If the filter fails to be set, the following display is shown before returning to its previous condi-

tion.

edit icon will be shown in the display.

• The AFR function is active

• The AFR function is inactive