Yamaha Clavinova CLP-880PE Посібник користувача - Сторінка 22
Переглянути онлайн або завантажити pdf Посібник користувача для Музичний інструмент Yamaha Clavinova CLP-880PE. Yamaha Clavinova CLP-880PE 40 сторінок. Clavinova
Друкувати сторінку
IJ IJ
I
Tuning
JJJ
Tuning makes it possible to adjust the pitch of the Clavinova over a 427.0 Hz
... 453.0 Hz (corresponding to the A3 note's Hz) range in approximately 0.2
Hertz intervals. Pitch control is useful for tuning the Clavinova to match other
instruments or recorded music.
I
I
SONG
D
Tuning Up ................................................................................................................
o
To tune up (raise pitch), hold the A-I and B-1 keys simultaneously.
~
Press any key between C3 and B3. Each time a key in this range is
pressed the pitch is increased by approximately 0.2 Hz.
The [-/NO] and
[+IYES]
buttons can also be used to tune down or up,
respectively, in approximately 1 Hz increments. Press the [-/NO] and
g~
[+/YES]
buttons simultaneously to recall standard tuning
(A3 =
440
Hz).
~
Release the A-I and B-1 keys.
SONG
"SELECT ...
Q~
D
Tuning Down .......................................................................................................
o
To tune down (lower pitch), hold the
A-I
and
A#-1
keys simulta
neously.
~
Press any key between C3 and B3. Each time a key in this range is
pressed the pitch is decreased by approximately 0.2 Hz.
The [-/NO] and
[+IYES]
buttons can also be used to tune down or up,
respectively, in approximately
1
Hz increments. Press the [-/NO] and
{+/YES]
buttons simultaneously to recall standard tuning (A3 = 440
Hz).
~
Release the A-I andA#-1 keys.
D
To Restore Standard Pitch ...................................................................
o
To restore the default pitch
(A3
=
440 Hz), hold the
A-I, A#-1
and
B-1 keys simultaneously.
~
Press any key between C3 and B3.
~
Release the
A-I, A#-1
and B-1 keys.
In terms of "Hertz", the overall tuning range is from 427.0 Hz to 453.0
Hz. The current tuning setting is shown on the LED display while the tuning
is being adjusted. Tenths of a Hertz are indicated on the LED display by the
appearance and position of one or two dots, as in the following example:
Display
Value
'-f'-fa
440.0
' - I. '-I
a
440.2
'-1'-1.a
440.4
' - 1 ' - 1
a
440.6
'-I. '-I
a
440.8
mE![~
.
An alternative tuning method is available in the Function mode - page 28.