Yamaha CONCERTVIBRAPHONES YV1605J Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Музичний інструмент Yamaha CONCERTVIBRAPHONES YV1605J. Yamaha CONCERTVIBRAPHONES YV1605J 16 сторінок. Vibraphones
Також для Yamaha CONCERTVIBRAPHONES YV1605J: Посібник користувача (18 сторінок)
Assembly
m
Connect the slide legs with the legs.
Align the legs from above so that the slide legs slide into the corresponding leg holes. Adjust to the
desired height and then securely tighten each slide leg fixing bolt, aligning it with the corresponding
notch of the slide leg. Fixing bolt and notch are aligned when the next lower notch is flush with the
upper leg flange.
Do not touch the notched
part during height adjust-
ment to avoid injury.
* The fourth notch from the tone bar side
corresponds to the standard height
setting.
,
After fixing the legs, connect the
pedal with the sustain damper.
Loosen the center rod fixing bolts to
extend the center rod, and insert the
center rod into the fitting of the rod
connector. Align the groove in the cen-
ter rod with the tip of the fixing bolt, and
then securely tighten the fixing bolt.
24
Align notch
with upper
flange.
When a slide leg fixing bolt is tightened in between two notches,
there is a danger of the slide leg slipping. Always make sure
that the slide legs are held securely.
High
Sound
Side
Rod Connector
Groove
Low
Sound
Side
Tighten
Center Rod
Pedal Rod