Yamaha TP-7020H Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Музичний інструмент Yamaha TP-7020H. Yamaha TP-7020H 12 сторінок. Pedal timpani
Також для Yamaha TP-7020H: Посібник користувача (12 сторінок), Посібник користувача (12 сторінок)

Друкувати сторінку

Adjusting The Sound Of Your Timpani

c Tuning Indicator Adjustment

The tuning indicator shows to which note the pedal is

set. After tuning the instrument, you must set each

note of the indicator to its proper position.

After you have tuned your timpani to the lowest

note of its tonal range, make sure that the pointer

is located within 10 mm from the pedal-side end

of the indicator rail.

* If not, adjust referring to "Adjusting the Pointer

Position".

Slide the lowest note of the indicator ("A" in case

of a 26" timpani — see "Standard Tonal Ranges

for Yamaha Timpani" on page 6) to the position

where its center line coincides with the pointer.

Tune the instrument to the next higher pitch

(note) by moving the pedal, and then slide the

corresponding note on the rail to the respective

pointer position. Repeat for each note.

* The tuning indicator can be set to a desired angle

by loosening the indicator mounting screw using a

Phillips screwdriver.

Indicator rail

Note

G Adjusting the Pointer Position

First loosen the pointer lock nut and then turn the

adjuster as follows:

After adjustment, securely tighten the pointer lock

nut.

Pointer

G Pointer is located beyond the lower rail end

when heel of pedal is lowered fully (lowest

note)

¡ Turn the adjuster to the left (counterclock-

wise) until the pointer is aligned with the

lowest note of the indicator.

G Pointer moves beyond the upper rail end

before toe of pedal reaches end of stroke,

Pointer does not reach lower rail end when

heel of pedal is lowered fully (lowest sound)

¡ Turn the adjuster to the right (clockwise) to

correct the pointer position as required.

Note

Indicator rail

Adjuster

Pointer

Adjustment nut