CALI alumLEDs ALS500T-SWM-TB Інструкція з монтажу Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Світильник CALI alumLEDs ALS500T-SWM-TB. CALI alumLEDs ALS500T-SWM-TB 20 сторінок.

Друкувати сторінку

Mount luminaire to Rail Brackets by sliding luminaire with assembled Hanging

Bracket Arms into Rail Brackets. Ensure each Hanging Bracket rests at the

center of each Rail Bracket.

Slide luminaire with Hanging

Bracket Arms onto Rail Bracket

Secure connections between continuous runs using Connector Blocks after all

luminaires have been mounted.

Note: Refer to steps on page 16 for details.

Install Ceiling Trim after all runs have been mounted and connected.

Note: Follow the steps on page 17 to install Ceiling Trim.

After all luminaires are mounted, adjust height and levelness of each luminaire

by tightening or loosening hex nuts on Hanging Bracket assembly.

Allow the weight of the luminaire to be suspended by the Hanging Bracket while

simultaneously resting on the flange of the T-Bar.

Note: One person holds the luminaire and another person adjusts hex nuts.

Tighten hex

nuts as needed

CALIFORNIA ACCENT LIGHTING, INC.

2820 E. Gretta Lane, Anaheim, CA 92806

ph. 800.921.CALI (2254) | fx. 714.535.7902 | [email protected] | calilighting.com

Ceiling Trim resting on T-Bar

ALS500T-SWM-TB

Mounting (Hanging Bracket Assembly ) 2 of 2

Secure a tie wire to each Hanging Bracket Arm after luminaires are set in place.

Note: Refer to the diagrams on page 3 for details.

If applicable, position the driver in the center of luminaire and secure using set

screws (by others). Do not mount drivers between luminaires.

Note: Driver size and location of mounting holes may differ from below example.

Make wiring connections from driver to 1st PCB. Pull lead wires from luminaire

and make splice connections to lead wires from driver. Verify wiring diagram

before connecting.

Perform a continuity test before connecting luminaire to power source.

Refer to page 19 for continuity test step by step.

Verify driver wire colors from wiring diagram, then connect luminaires to power

source. Drivers used for this product vary. Always confirm wiring diagram from

driver installation instructions before connecting.

Apply mud to Wall Trim until completely covered and smooth. Allow to dry

completely before painting or sanding. Do not use pre-mixed mud compounds.

After all installation steps are complete and lighting is confirmed to be working,

install reflective film to runs.

Note: Follow the steps on page 18 to install reflective film.

INSTALLATION INSTRUCTIONS

Lead Wire

1 / 29 / 2021 / Rev 2

Page 5 of 20