CALI alumLEDs ALS600T-AD Series Посібник з монтажу - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник з монтажу для Світильник CALI alumLEDs ALS600T-AD Series. CALI alumLEDs ALS600T-AD Series 11 сторінок.
Друкувати сторінку1.
Measure area where luminaire will be installed. Use a chalk line to ensure a straight installation.
2.
Mark location where mounting clips will be installed along chalk line.
3.
Use 2 mounting clips for each fixture.
4.
Lay mounting clips and pre-drill using proper drill bit for surface and screw size.
Recommendation: 8/32 x 1" screw.
Note: Allow 0.25" clearance for lateral expansion of assembled mounting clips.
Only install mounting clips on flat, even surfaces.
5.
Screw mounting clips to surface, then snap fixture into mounting clips. Install set
screws if needed. Set screws are required for downward and outward facing applications.
Set Screw
CALIFORNIA ACCENT LIGHTING, INC.
2820 E. Gretta Lane, Anaheim, CA 92806
ph. 800.921.CALI (2254) | fx. 714.535.7902 | [email protected] | calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
2019.12.5 Rev 2
4'
Mounting Clip
2"
2"
3'
2"
2"
2'
2"
2"
1'
2"
2"
ALS600T-AD
ASSEMBLED END VIEWS
2.55"
2.89"
Without Louver (Closed)
3.56"
4.12"
Without Louver (Open)
alumLEDs
Page 4 of 11
INSTALLATION
Mounting Clips
2.65"
3.82"
With Louver (Closed)
4.49"
4.22"
With Louver (Open)
Manufactured in the U.S.A.
™