Yamaha YDP-151 Посібник користувача - Сторінка 36
Переглянути онлайн або завантажити pdf Посібник користувача для Електронна клавіатура Yamaha YDP-151. Yamaha YDP-151 50 сторінок. Yamaha ydp-131: quick start
Також для Yamaha YDP-151: Посібник користувача (49 сторінок), Короткий посібник з експлуатації (2 сторінок)
Друкувати сторінку
7.
Set the voltage selector and connect the
power cord.
127
240
Voltage Selector
Before connecting the AC power cord, check the setting
of the voltage selector which is provided in some areas.
To set the selector for 110V, 127V, 220V or 240V main
voltages, use a "minus" screwdriver to rotate the selector
dial so that the correct voltage for your region appears
next to the pointer on the panel. The voltage selector is
set at 240V when the unit is initially shipped. After the
proper voltage has been selected, connect the AC power
cord to the AC INLET and an AC wall outlet. A plug
adaptor may be also provided in some areas to match the
pin configuration of the AC wall outlets in your area.
After completing the assembly, please
check the following.
• Are there any parts left over?
➝ Review the assembly procedure and correct any
errors.
• Is this instrument clear of doors and other mov-
able fixtures?
➝ Move the instrument to an appropriate location.
• Does this instrument make a rattling noise
when you shake it?
➝ Tighten all screws.
• Does the pedal box rattle or give way when you
step on the pedals?
➝ Turn the adjuster so that it is set firmly against
the floor.
• Are the pedal and power cords inserted securely
into the sockets?
➝ Check the connection.
• If the main unit creaks or is otherwise unsteady
when you play on the keyboard, refer to the
assembly diagrams and retighten all screws.
36
Keyboard Stand Assembly
YDP-151/YDP-323
WARNING
An improper voltage setting can cause serious
damage to this instrument or result in improper
operation.
8.
Set the adjuster.
Rotate the adjuster until it comes in firm contact with the
floor surface.
9.
Attach the headphone hanger.
Use the included two screws 5 (4x10mm) to
attach the hanger as shown in the illustration
below.
When moving the instrument after assembly, always
hold the bottom of the main unit.
CAUTION
Do not hold the key cover or top portion. Improper
handling can result in damage to the instrument or
personal injury.
Key cover
Do not
Hold here.
hold here.
Top portion
Do not hold here.