Yamaha CP2000 Посібник користувача - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Yamaha CP2000. Yamaha CP2000 20 сторінок. Yamaha power amplifier owner's manual
Також для Yamaha CP2000: Посібник з експлуатації (33 сторінок), Посібник з експлуатації (33 сторінок)
Друкувати сторінку
4
Chapter 2—Hookup Examples
E
GND terminal
For safety reasons it's important that the CP2000 is grounded. The attached power cord
has a three-pin plug, and if the ground terminal of the AC outlet to which it is con-
nected is grounded, then the CP2000 will be grounded adequately via the power cord.
If the AC outlet does not have a suitable ground terminal, a ground connection should
be made to this ground terminal. If hum or noise occurs, try to eliminate it by connect-
ing this terminal to a good ground point or the chassis of the mixer, preamp, etc.
2 Hookup Examples
Stereo Hookup
In STEREO mode, the L and R channels operate independently. This mode is typically
used to amplify stereo sources. The following hookup example shows how the CP2000
can be used in STEREO mode.
STEREO
BRIDGE
PARALLEL
INPUT
CHANNEL R
STEREO
BRIDGE
PARALLEL
2
1
OFF
ON
3
YAMAHA
SPEAKER PROCESSING
ST OUT
Mixer
STEREO Notes:
• The stereo input source is connected to the L
and R inputs.
• The Channel L and Channel R volume levels
can be set independently.
• Speakers can be connected to the 1/4" phone
jacks and 5-way binding posts.
CP2000—Owner's Manual
CHANNEL L
(BRIDGE)
NEUTRIK
2
1
3
or
2
1
(–)
CHANNEL R
SPEAKERS
Total impedance:
2 min (1000 W)
4 (650 W)
8 (450 W)
1
2
BRIDGE
(+)
CHANNEL L
Total impedance:
2 min (1000 W)
4 (650 W)
8 (450 W)