Yamaha XM4220 Посібник користувача - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Yamaha XM4220. Yamaha XM4220 13 сторінок. Yamaha power amplifier owner's manual
Друкувати сторінку
Troubleshooting
The following table lists the main causes of abnormal operation and the corrective measures required as well as the
protective circuit operation in each case.
Indicator
CLIP indicator lights up
PROTECTION indicator
lights up
12
Possible Cause
There is a short at the
amplifier's speaker
outputs, the speaker's
inputs, or in the wiring.
The impedance of the
connected speaker
is too low.
The heat sink temperature
has exceeded 90 C.
A DC voltage of 2 V
or greater was detected
in the amplifier's output
circuit.
Remedy
Locate and remove
the short.
Use a speaker with a
minimum impedance
of 4 (8 in Bridge
mode).
Check the ventilation
around the amplifier
and improve the airflow
if necessary.
Consult your dealer
or a Yamaha service
center.
Protection Circuit
The PC limiter circuit
activates to protect
the power transistors.
The thermal protection
circuit activates to
protect the power
transistors.
The output relay activates
to protect the speaker
system.