Yamaha XP3500 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Yamaha XP3500. Yamaha XP3500 22 сторінки. Xp series power amplifier
Також для Yamaha XP3500: Посібник користувача (20 сторінок), Посібник користувача (20 сторінок), (Англійська) Інструкція з експлуатації (20 сторінок)

Друкувати сторінку

■

Rear Panel

XLR inputs connectors

These balanced XLR-3-31 type connectors are used to

connect input signals.

The pins are wired as shown below (IEC 60268).

Hot

* In bridged mode, only the ﬁrst channel in the pair

is active; i.e., channel A of pair A/B. Make sure not

to input an audio signal to an inactive input termi-

nal.

Euroblock connectors

These balanced Euroblock connectors are used to con-

nect input signals.

HPF switches

These switches are used to turn on and off the HPF

(High Pass Filter) for each channel. When this is set to

20Hz or 55Hz, frequencies below the respective settings

are ﬁltered using a 12 dB/octave high pass ﬁlter.

GAIN switch

This switch is used when changing the Gain of the A

and B channels simultaneously.

• +4dBu: The maximum output power can be

obtained when +4dBu is input.

• 26dB: Setting of 26dB

• 32dB: Setting of 32dB

Ground

Cold

MODE switch

• STEREO mode

In STEREO mode, channels A and B are completely

independent.

• PARALLEL mode

In PARALLEL mode, the channel A input signal is

sent both to the channel A power amp and the channel

B power amp. In this case, loads are automatically

connected between the A and B input terminals.

• BRIDGED mode

In BRIDGED mode, channels A and B operate simul-

taneously, functioning as a single mono ampliﬁer.

Note: When in PARALLEL and BRIDGED modes,

input terminals A and B are shorted auto-

matically. Make sure not to input an audio

signal to an inactive input terminal.

MONITOR/REMOTE terminals

This terminal is used to connect the external device for

monitoring or remote control. Refer to "MONITOR/

REMOTE PIN layout" on page 15.

SPEAKERS terminals

1: These 5-way binding posts are used to connect

speakers.

2: These are Speakon type output jacks. Speakon type

cable plugs can be connected here.

GND terminal

If you are having a problem with hum or noise, use this

terminal to connect to ground (earth) or to connect to

the chassis of a mixer, preamp, or other device in your

system.

XP7000/XP5000/XP3500/XP2500/XP1000 Owner's Manual