Yamaha CBR15 Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Акустична система Yamaha CBR15. Yamaha CBR15 8 сторінок. Cbr series
Також для Yamaha CBR15: Посібник користувача (4 сторінок), Посібник користувача (1 сторінок)
Друкувати сторінку
CAUTION
• Before doing any installation or construction work, consult with your Yamaha dealer.
• For optimum safety, the installation should be checked thoroughly at regular intervals. Some fittings may deteriorate over
extended periods of time due to wear and/or corrosion.
• When choosing the installation location, suspension wire and mounting hardware, make sure all are strong enough to
support the weight of the speaker.
• Make sure to take measures to prevent the speaker from falling down in the event of a installation failure.
• When installing the safety wire to the wall, install it higher than the wire's attachment point on the speaker, with as little
slack as possible. If the wire is too long, and the speaker happens to fall, the wire may snap as a result of too much strain.
Yamaha cannot be held responsible for damage or injury caused by insufficient strength of the support
structure or improper installation.
Installation using separately sold Yamaha speaker
brackets
Attach the bracket to two screw holes at the bottom of the unit using commercially available screws
(M8 x 16 mm) or eye bolts (M8 x 15 mm). For details on installing the bracket, refer to the corresponding
manual.
❚ ❚
Using the BWS251-300 or BWS251-400 wall mounting bracket
Maximum tilt
angle
❚ ❚
Using the BCS251 ceiling bracket
❚ ❚
Using the BBS251 baton bracket
The tilt angle depends on the position relation between the speaker
and the wall. The maximum downward tilt angle is shown in the
following chart.
Maximum tilt angle
CBR15
CBR12
CBR10
Max. 45°
Installation E
BWS251-300
8°
11°
20°
(Pullback point for CBR15
and CBR12 only)
BWS251-400
17.5°
23°
35°