Caliber 35460 Посібник користувача - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник користувача для Спікери Caliber 35460. Caliber 35460 14 сторінок. Snap lock in-wall/in-ceiling speakers

Друкувати сторінку

11. Route your speaker wire from the back of your amplifier, through the wall or ceiling,

to the installation location.

12. If you have not already done so, completely remove the grille, which is held in place

with magnets for ease of removal.

13. Depress the positive/red push terminal on the back of the speaker and insert the

bare wire lead or pin plug into the hole. Release the terminal.

14. Depress the negative/black push terminal and insert the bare wire lead or pin plug

into the hole. Release the terminal.

15. Give a gentle tug on each lead to ensure that they are securely connected to the

terminals.

16. Ensure that the mounting tabs on the speaker assembly are turned inwards.

17. Position the speaker into the hole.

18. Push the round end (labeled install) of the included L-shaped installation tool into

each of the four holes on the speaker frame. The spring locks will snap into place,

securing the speaker to the wall or ceiling.

19. Replace the magnetic grille onto the speaker frame.

20. Ensure that your amplifier is powered off and unplugged from the power source.

21. Connect the amplifier end of the speaker wire to one of the speaker level outputs

on your amplifier, taking care to match the polarity markings on the speaker wire or

plugs.

22. Repeat the above for the other speaker.

Congratulations, your speakers are installed and ready for use!