Clarke 3110380 Інструкція з експлуатації та обслуговування - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з експлуатації та обслуговування для Електроінструмент Clarke 3110380. Clarke 3110380 11 сторінок. Air stapler

Clarke 3110380 Інструкція з експлуатації та обслуговування

SAFETY PRECAUTIONS

Failure to follow these precautions could result in personal injury, and/or
1.
When operating this tool, ALWAYS wear:
a. approved impact resistant SAFETY GOGGLES. (Eye glasses are NOT safety
glasses)
b. EAR DEFENDERS
c.
a good pair of INDUSTRIAL GLOVES
2.
ALWAYS disconnect the tool from the air supply when not in use, and before
carrying out any maintenance
3.
ALWAYS keep a safe distance between yourself and others when using the
tool.
4.
ALWAYS Maintain the tool with care. Keep it clean for best/safest performance.
5.
NEVER wear ill fitting clothing, remove watches and rings.
6.
NEVER over-reach. Keep your proper footing and balance at all times.
7.
NEVER force or misuse the tool. It will do a better and safer job at the rate for
which it was designed.
8.
NEVER abuse hoses or connectors. NEVER carry a tool by the hose, or yank it
to disconnect from the air supply. Keep hoses away from heat, oil and sharp
edges. Check hoses for leaks or worn condition before use, and ensure that
all connections are secure.
9.
NEVER use with an air supply greater than 8bar (110 PSI), at the tool.
10. NEVER modify the tool in any way.
11. NEVER remove any labels. Damaged labels should be replaced.
12. NEVER point the tool at anyone.
13. NEVER carry the tool with your finger on the trigger.
14. NEVER use any other type of gas to operate this tool. Use compressed air ONLY.
15. NEVER load the tool with Staples BEFORE connecting to an air supply.
16. NEVER load the tool with the trigger depressed
17. NEVER use this tool if any part is damaged. Have it inspected and repaired
by a competent technician
18. NEVER modify this tool in any way. Use it ONLY for the purpose for which it is
designed.
19, NEVER fire tool at an angle. it must be perpendicular to the work surface.
20. NEVER drive in Staples at the edge of a work surface, as the edge could fail
and fly off, endangering yourself or others in the vicinity.
IMPORTANT
damage to property.
4