Directed AS-3472TW Посібник користувача - Сторінка 15

Переглянути онлайн або завантажити pdf Посібник користувача для Пульт дистанційного керування Directed AS-3472TW. Directed AS-3472TW 20 сторінок.

Друкувати сторінку

Ignition-controlled Door Locks

This is an added security feature. If your Remote Car Starter was installed with the Ignition-

Controlled Door Locks option, the doors will automatically lock as soon as the ignition key is turned

to the IGNITION ON (RUN) position while the brakes are pressed. The remote car starter will also

lock any door that was unlocked and opened (then closed) the next time the brake pedal is pressed

(only when doors are monitored). When the key is turned to the OFF position, the doors will

automatically be unlocked.

Secure Lock

Before it can remote-start your vehicle, the remote starter must first disarm the factory security

system. The secure lock feature may be required on certain vehicle models with factory security

systems that automatically unlock the doors when the security system is disarmed. To keep your

vehicle protected when the factory security system is disarmed for a remote start, secure lock will

relock your doors as soon as the vehicle has started. Once the engine run cycle ends, secure lock

will rearm your factory security system.

Safe Start

This feature will eliminate accidental remote starts, e.g. when children are playing with the

transmitter.

Safe start enabled: If this feature is enabled, the user must press the

3 seconds to remote-start the vehicle.

Swap start: If this feature is enabled;

2-way remote:

1. Through the remote's advanced function menu (page-6), select L-01.

2. Press

to remote start the vehicle.

Note: The AUX 2 output can be activated by pressing the

1-way remote:

1. Rapidly press AUX twice. While the remote's LED is flashing, press

vehicle.

Note: The AUX 2 output can be activated by pressing the

Engine Run Time

On a gas engine, the Remote Car Starter can be programmed to run the engine for 3, 15, or

25 minutes (15 minutes by default). On a diesel engine, the Remote Car Starter can be

programmed to run the engine for 8, 20, or 30 minutes (20 minutes by default).

Turbo Mode

If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user

leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it

is shut down by remote control), then shut down the engine.

If your vehicle has an automatic transmission, proceed as follows to set the system to Turbo Mode:

With the engine running, make sure to release the brake pedal and press the

button on the transmitter until the parking lights come ON.

Note: SmartStart™ can be setup to use the SmartStart™ icon to activate Turbo mode.

Remove the ignition key from the ignition switch. The engine will continue running.

Exit the vehicle and close all doors, hood and trunk.

Press the

confirm that the vehicle is in Turbo Mode.

User Guide

button; this will lock the doors, arm the OEM-style alarm (if configured) and

button twice within

button.

to remote start the

button.

P.15