Clarke 3400757 Інструкція користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція користувача для Електроінструмент Clarke 3400757. Clarke 3400757 13 сторінок. Hot air gun

REMOVING PAINT FROM WINDOW FRAMES

DO NOT point the gun directly at

glass and always ensure it is

adequately protected. A glass

protection nozzle is provided for use

when stripping window frames etc.

1. Fit the glass protection nozzle to

the front of the hot air gun and

angle it so that the gun can be

placed up against the window,

with the cowl of the nozzle, flat

against the glass as shown.

2. It will be necessary to change the position of the protection nozzle as you

work around the window pane. Ensure you wear adequate hand

protection when doing so.

3. The protection nozzle must be kept in contact with the work at all times, but

do not spend too much time in one area.

To prevent the gun from overheating, maintain a minimum distance of 3 cm

between the end of the nozzle and the work piece.

IMPORTANT: In continuous operation, never exceed the duty cycle for the

unit as stated in the specification.

When bending or forming plastic parts, work slowly and with great care

observing the effects of heat on such materials.

NOTE: With plastics, the temperature range between solid, pliable and

liquid states is narrow, therefore great care should be taken.

The gun is ideal for speeding up the defrosting of water pipes.

1. Always heat frozen areas inwards from the edge to the centre.

2. Take special care when defrosting plastic pipes.

3. Provide protection against heat damage to nearby paint and wall

coverings where necessary.

4. Be aware that copper gas pipes can be difficult to distinguish from copper

water pipes. Always check first.

5. Copper pipes are often soldered together, therefore should not be heated

above 200

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]