Clarke CAT134 Інструкція з експлуатації та обслуговування - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та обслуговування для Електроінструмент Clarke CAT134. Clarke CAT134 17 сторінок. Air ratchet wrench
Друкувати сторінку
SETTING THE SPEED
1. Set the tool speed by rotating the
control to one of the four settings.
• The graduations on the speed
control indicate the speed
setting when aligned with the
reference mark on the air inlet.
• Speeds available are: 45, 85,
140 or 180 rpm (+/-10%).
NOTE: When critical torque values
are not required, turn the nut
or bolt until it is snug - slightly tighter if gaskets are used between
surfaces.
Where torque settings are critical, the final tightening of nuts or bolts must be
by hand, using a calibrated torque wrench.
SETTING THE EXHAUST DEFLECTOR
The direction of the exhaust air
leaving the tool can be adjusted by
rotating the exhaust deflector.
Twist the exhaust deflector sleeve to
direct the air as required to deflect air
away from the workpiece or operator.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the air supply hose until the compressor has been shut
down and the compressed air released.
2. Refer to the compressor instruction manual for the procedure to shut down
and vent the compressed air.
3. Once the pressure has been released, disconnect the air supply hose from
the air tool.
4. Store the tool safely in its box in a dry, secure environment.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
9