Clarke CHG1500D Інструкція користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція користувача для Електроінструмент Clarke CHG1500D. Clarke CHG1500D 13 сторінок. Hot air gun

OPERATION

Before starting work it is recommended that you heat a test piece to ensure

you have the correct heat setting. In addition you should always take steps to

protect sensitive or delicate areas where the effect of heat could cause

damage (i.e. glass and plastics). Do not apply heat to the same place for a

long time.

After the work has been completed, switch the gun OFF, disconnect from the

mains supply and allow to cool in a safe place.

Take care not to drop the gun as this could seriously damage the heating

element.

The gun can be used in conjuction with a shavehook to remove paint.

1. With the switch in the '0' (OFF) position plug the hot air gun into the mains

supply.

2. Set the switch to either position I

or II according to how much heat

is required. (see Specification on

page 10).

• Ensure the nozzle is pointing

away from you.

3. Bring the nozzle of the hot air gun

to the work piece approximately 3

cm from the surface.

• The exact distance between

the nozzle and the work piece will be dependent on the material

being worked on.

• Paint will rapidly become soft and blister, at which point it can be

removed with a suitable scraper. Do not allow paint to burn as this

will make the removal process more difficult.

• Some adhesives soften when heated and the joint can then be

separated, taking care to avoid damage to jointed parts.

4. Clean your shavehook quickly if paint/glue becomes stuck to it.

• Profiled parts may be cleaned with a suitable wire brush once paint

is softened.

• Normally only one pass is required to remove both thick and thin

layers of paint.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]