Clarke Metalworker CDP101B Посібник з експлуатації та обслуговування - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з експлуатації та обслуговування для Електроінструмент Clarke Metalworker CDP101B. Clarke Metalworker CDP101B 19 сторінок. 13mm drill press
Друкувати сторінку
ELECTRICAL CONNECTIONS
Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an
approved 13 amp BS 1363 plug, or a suitably fused isolator switch.
WARNING! THIS APPLIANCE MUST BE EARTHED
IMPORTANT: The wires in the mains lead are coloured in accordance with the following
code:
As the colours of the flexible lead of this appliance may not correspond with the coloured
markings identifying terminals in your plug proceed as follows:
Connect GREEN & YELLOW cord to terminal marked with a letter "E" or Earth symbol
"
" or coloured GREEN or GREEN & YELLOW.
Connect BROWN cord to terminal marked with a letter "L" or coloured RED.
Connect BLUE cord to terminal marked with a letter "N" or coloured BLACK.
If this appliance is fitted with a plug which is moulded onto the electric cable (i.e. non-
rewirable) please note:
1.
The plug must be thrown away if it is cut from the electric cable. There is a danger of
electric shock if it is subsequently inserted into a socket outlet.
2.
Never use the plug without the fuse cover fitted.
3.
Should you wish to replace a detachable fuse carrier, ensure that the correct
replacement is used (as indicated by marking or colour code).
4.
Replacement fuse covers can be obtained from your local dealer or most electrical
stockists.
5.
The fuse in the plug must be replaced with one of the same rating (13 amps) and this
replacement must be ASTA approved to BS1363.
WIRING DIAGRAM
Green & Yellow
-
Earth
Blue
-
Neutral
Brown
-
Live
6