Clarke STRONG-ARM CS10SBRK Інструкція з експлуатації та технічного обслуговування - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та технічного обслуговування для Електроінструмент Clarke STRONG-ARM CS10SBRK. Clarke STRONG-ARM CS10SBRK 17 сторінок. Body repair kit
Друкувати сторінку
MAINTENANCE
If the pump has been stored for long
periods, check the oil level before
use. Stand the pump on a level
surface and remove the breather
valve on the oil reservoir. If necessary,
top up via the breather valve which is
then screwed on finger tight.
NOTE: Only unscrew this when the
system is not under pressure.
The oil level should be near the
bottom of the opening. If required, oil can be topped top using Clarke
Hydraulic Oil. (part no. 3050830 for 1 litre).
After extensive use, the hydraulic oil should be replaced to ensure longer
equipment life. Do not overfill, or the piston rod will be unable to move freely.
Replace the breather valve after re-filling. The required oil volumes are as
follows.
• CS4BRK - 250 ml + 5ml
• CS10BRK/CS10SBRK - 500 ml + 5ml
STORAGE
After use, screw the valve cover on
to the pump to keep the connection
clear of dust and dirt and cover the
hydraulic hose end with the plastic
cap.
When not in use, the pump should be
stored with the release valve open.
Store all the equipment in its case in a
clean, dry environment protected
from the weather.
ENVIRONMENTAL PROTECTION
One of the most damaging sources of environmental pollution is oil products.
Never throw away used hydraulic oil with domestic refuse or flush it down a
sink or drain. Collect any hydraulic oil in a leak proof container and take it to
your local waste disposal site.
If disposing of this product or any damaged components, do not dispose of
with general waste. This product contains valuable raw materials and should
be taken to your local civic amenity site for recycling of metal products.
10