Zanussi ZBA6230A Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Холодильник Zanussi ZBA6230A. Zanussi ZBA6230A 12 сторінок. Refrigerator

Друкувати сторінку
Periods of non-operation
When the appliance is not in use for long periods, take
the following precautions:

What to do if...

Warning! Before troubleshooting, disconnect the
mains plug from the mains socket.
Only a qualified electrician or competent person must do
the troubleshooting that is not in this manual.
Problem
The appliance does not operate.
The lamp does not operate.
The lamp does not work.
The compressor operates con-
tinually.
Water flows on the rear plate of
the refrigerator.
Water flows into the refrigerator. The water outlet is clogged.
3) If foreseen.
6
Possible cause
The appliance is switched off.
The mains plug is not connected to the
mains socket correctly.
The appliance has no power. There is
no voltage in the mains socket.
The lamp is defective.
The temperature is not set correctly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too high.
The room temperature is too high.
During the automatic defrosting proc-
ess, frost defrosts on the rear plate.
Products prevent that water flows into
the water collector.
• disconnect the appliance from electricity supply
• remove all food
• defrost
3)
and clean the appliance and all accessories
• leave the door/doors ajar to prevent unpleasant smells.
If the cabinet will be kept on, ask somebody to check it
once in a while to prevent the food inside from spoiling
in case of a power failure.
Important! There are some sounds during normal use
(compressor, refrigerant circulation).
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appliance
to the mains socket.
Contact a qualified electrician.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer than
necessary.
Let the product temperature decrease to
room temperature before storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not touch
the rear plate.
Solution