Zanussi ZBT20420SA Посібник користувача - Сторінка 19
Переглянути онлайн або завантажити pdf Посібник користувача для Холодильник Zanussi ZBT20420SA. Zanussi ZBT20420SA 45 сторінок.
Також для Zanussi ZBT20420SA: Посібник користувача (28 сторінок), Посібник користувача (48 сторінок)
Друкувати сторінку
Problem
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
REPLACING THE LAMP
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the
illustration).
INSTALLATION
WARNING! Refer to Safety chapters.
Possible cause
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
3. Replace the used lamp with a new lamp of the
same power and specifically designed for
household appliances (the maximum power is
shown on the lamp cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.
CLOSING THE DOOR
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to assembly
instructions.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
Solution
Make sure that food products do
not touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessary.
19