Zanussi ZI 230 Z Інструкція з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Холодильник Zanussi ZI 230 Z. Zanussi ZI 230 Z 12 сторінок.

Open both the appliance door and that of the

kitchen unit to approx. 90¡. Place the little plates

over the runners. Hold the doors of the appliance

and the unit together and mark the holes.

Remove the little plates and make the holes with a

diam. of 2 mm. Replace the little platee over the

runners and screw in the screws provided (3.5x16

mm).

For the alignment of the kitchen unit door, if

necessary, use the clearance size of the slotted

holes. At the end of the procedure, check that the

doors of the appliance and the kitchen unit open

properly.

Inner door reversal

Using a screwdriver release bracket (1) by

pressing on the internal spring (Fig. 10) and

withdraw it from its seat together with the door;

remove plug (2) and fit it in the hole left open on

the opposite side;

turn the door through 180¡, remove the bracket (1)

and refit it on the opposite side. Refit the door and

insert the top pin and bottom bracket (1), pushing

it into place.

To ensure correct storage of food, the door is fitted

with a simple spring device which holds it in the

open position until it is properly closed.

Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond

to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with

different voltages, a suitably sized auto-transformer must be used.

The technical data is indicated in the rating plate on the left side inside the appliance.

TECHNICAL SPECIFICATIONS

180

PR140

Fig. 9

Fig. 10

Fig. 11