Zanussi ZR 6/L Інструкція із застосування та догляду - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція із застосування та догляду для Холодильник Zanussi ZR 6/L. Zanussi ZR 6/L 8 сторінок. Zanussi refrigerators instructions for the use and care
Також для Zanussi ZR 6/L: Інструкція з використання та догляду (8 сторінок), Інструкція з використання та догляду (8 сторінок)
Друкувати сторінку
Installation
Foreword
If you are discarding an old refrigerator
that has a lock on the door, please ensure
that the lock is made unusable to avoid
accidents to young children.
Electricity Supply
The appliance is for operation on a
220/240 V. 50 Hz supply, so be sure that
your electricity supply voltage is within
the range marked on the nameplate
located inside the cabinet.
Earthing
WARNING: THIS APPLIANCE MUST BE
EARTHED. The manufacturer declines
any liability should this safety measure
not be observed.
If the plug that is fitted to your appliance
is not suitable for your socket outlet, it
must be cut off and the appropriate plug
fitted. The cut off plug should be disposed
of to prevent the hazard of electric shocks
in case it should be plugged into a 13 Amp
socket in another part of your home.
Electrical connection
IMPORTANT: The wires in this mains
lead are coloured in accordance with
the following code:
GREEN AND YELLOW - EARTH
BLUE-NEUTRAL
BROWN-LIVE
If you fit your own plug, the colours of
the wires in the mains lead of your
appliance may not correspond with the
markings identifying the terminals in
your plug, this is what you have to do:
Connect the green and yellow (earth) wire
to the terminal in the plug which is
marked with the letter "E" or the earth
symbol -A* , or coloured green, or
green and yellow.
Connect the blue (neutral) wire to the
terminal in the plug which is marked with
the letter "N" or coloured black.
Connect the brown (live) wire to the
terminal which is marked with the letter
"L" or coloured red.
The plug moulded on to the cord
incorporates a fuse. For replacement use
a 13 Amp BS 1362 fuse. Only ASTA
approved fuses should be used.
The fuse cover/carrier must be replaced in
the event of changing fuse.
The right fuse cover/carrier colour is the
one shown by the coloured insert at the
base of the plug or is the colour of the
inscription at the base of the plug.
The plug must not be used if the fuse
cover/carrier is lost
A replacement cover/carrier must be
obtained from Zanussi Service Agents
whose addresses are listed on the
attached "Zanussi Service and Spares
Nationwide".
This appliance complies with E.E.C.
directive no. 82/499 of 7.6.82 relative
to radio interference suppression.
Some models have the main terminal
board of the type shown in fig. 1.
To gain access to the terminals of the
supply cable, remove the lid from the
terminal board by releasing the two
catches "A" and "B" Fig. 1 with the aid
of a small blade screwdriver.
2